Today I was at Bert PE1RKQ his station. I installed the rotator that I had repaired before in his tower again.
Installed the new high voltage board in the GS35 144mhz amp and tested it.
I got my new touch screen. I want to use this with the Green Heron rotator software. The isea is to get for each rotor 8 preset directions. Only on touch is needed to let the rotor go to his new position.
Started to asemble a new cirquit board to replace the high voltage board in one of the 144mhz gs35 Amps.
The actuator used for elavation stopped working.
I took it off of the system cleanend it. Then I replaced it. I have got a better one from PA0BAT one will put this one up in future.